User Guide
Table Of Contents
- Altivar Machine ATV320
- Table of Contents
- Safety Information
- About the Book
- Introduction to Device Conversion Function
- Control Block Terminals
- Functions Compatibilities
- Applicative Functions
- Reverse
- Reverse Inhibition
- Speed Loop Parameters
- Macro-Configurations
- I/O Multi-Assignments
- 2/3 Wires Control
- Freewheel Stop
- Fast Stop
- Ramp Types
- Ramp Switching
- Ramp Auto-Adaptation
- DC Injection Braking
- Reference Switching
- Separate Mode (Command & Reference)
- Reference Operation
- Jog
- Preset Speeds
- Brake Control Sequence
- +/- Speed
- 2nd Current Limitation
- Jump Frequency
- PID Regulator
- Internal PID reference
- Preset PID Reference
- Sleep / Wake-Up
- Catch On the Fly
- Automatic Restart
- Multi-Motors / Multi-Configurations
Function Compatibilities
QGH39563 02/2017 27
Macro-Configurations
Overview
This function is available in both ATV312 and ATV320 drives but macro-configuration lists are not the
same.
On ATV312, there are 2 sets of macro configurations.
On ATV320, there are 6 sets of macro configurations.
Device Conversion
Conversion from an ATV312 configuration into ATV320 configuration is not supported for this function.
The parameters related to this function are set to factory setting values and needs to be adjusted
depending on the application.
For more information about macro-configuration, refer to the ATV320 Programming Manual (
NVE41295
).
I/O Multi-Assignments
Overview
This function is available in both ATV312 and ATV320 drives.
Device Conversion
Conversion from an ATV312 configuration into ATV320 configuration is supported for this function with
some limitation that is; if the digital output is used in combination with the brake sequence, conversion is
not possible.
The parameters related to this function are set to factory setting values and needs to be adjusted
depending on the application.
For more information about I/O Multi-Assignments, refer to the ATV320 Programming Manual
(
NVE41295
).
2/3 Wires Control
Overview
This function is available in both ATV312 and ATV320 drives.
Device Conversion
Conversion from an ATV312 configuration into ATV320 configuration is supported for this function.
For more information about 2/3 Wires Control, refer to the ATV320 Programming Manual (
NVE41295
).