Install Instructions

60 S1A53832 03/2019
Control terminals and switches
Preliminary recommendations
Connect the control terminals after connecting the power terminals.
The logic input switch SW102 assigns the logic input type to either 24 V (source logic) or 0 V (sink logic).
Refer to “Logic Input Switch” on page 38 for recommended circuit diagrams for source and sink logic.
DANGER
UNINTENDED EQUIPMENT OPERATION
 Prevent accidental grounding of logic inputs configured for sink logic. Accidental grounding can result in
unintended activation of drive functions.
 Protect the signal conductors against damage that could result in unintentional conductor grounding.
 Follow NFPA 79 and EN 60204 guidelines for proper control circuit grounding practices
Failure to follow these instructions will result in death or serious injury.
DANGER
UNINTENDED EQUIPMENT OPERATION
 Modify only the setting of switches when the product is switched off.
 Do not change the setting of switch SW102 unless your system is wired for sink logic.
Failure to follow these instructions will result in death or serious injury.
CAUTION
RISK OF BODY INJURY
use a screwdriver to change the position of the switches.
Failure to follow these instructions can result in injury or equipment damage.