Install Instructions
Table Of Contents
- Table of Contents
- Safety Information
- About the Book
- Before You Begin
- Steps for Setting Up
- Upstream Protective Device
- Technical Data
- Installation
- Drive mounting generalities
- Specific recommendations for mounting in an enclosure
- Position of the charging LED
- Opening the drive to access terminals
- Wiring recommendations
- Power terminals
- Control terminals and switches
- Installing option card
- Use on an impedance grounded (IT) system
- Electromagnetic compatibility (EMC)
- Checking the Installation
- Recommended branch circuit protection devices
- Maintenance
- Migration ATV21 --> ATV212
S1A53832 03/2019 51
Terminal location on ATV212H
On drives ATV212H075M3X...U22N4 (page 14) first remove control board to access power terminals.
1 Remove the terminal board mounting screw and take off the ATV212 standard terminal board. Be careful not
to lose the terminal board mounting screw.
2 Connect the power terminals
3 Reinstall the terminal board and fit the board mounting screw (M3 tapping type) and tighten to 0.7 to 0.8Nm.
ATV212W up to 7.5 kW ATV212W above 7.5 kW
Control terminals
Power terminals