Install Instructions
Table Of Contents
- Table of Contents
- Safety Information
- About the Book
- Before You Begin
- Steps for Setting Up
- Upstream Protective Device
- Technical Data
- Installation
- Drive mounting generalities
- Specific recommendations for mounting in an enclosure
- Position of the charging LED
- Opening the drive to access terminals
- Wiring recommendations
- Power terminals
- Control terminals and switches
- Installing option card
- Use on an impedance grounded (IT) system
- Electromagnetic compatibility (EMC)
- Checking the Installation
- Recommended branch circuit protection devices
- Maintenance
- Migration ATV21 --> ATV212
50 S1A53832 03/2019
Position of the charging LED
Opening the drive to access terminals
Procedure
1 Any procedure in this section must be performed when product is powered off.
2 Open the ATV212 front cover.
RUN
PRG
MON
%
Hz
MODE
Loc
Rem
ENT
RUN STOP
The capacitor charging LED on
the drive is not an indicator of the
absence of DC bus voltage. It
only indicates when the
capacitor is fully charged.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH
Read and understand the instructions in "before you begin" chapter, before performing the procedure in this
section.
Failure to follow these instructions will result in death or serious injury.
ATV212H products up to 22 kW
.
Turn the screw on the
front panel 90°
counter-clockwise to
align the dot on the
screw with the unlock
position.
To avoid damaging the
screw, do not
apply excessive force or
turn the screw more than
90°.
ATV212H products from 22 kW
Remove the screws.
Lift off the cover.
Pull the front panel toward you and
swing it open to the left
Screw