Install Instructions

40 S1A53832 03/2019
Drive mounting generalities
Attaching A Label With Safety Instructions
A label kit is provided with the drive.
Mounting and temperature conditions
NOTICE
RISK OF DAMAGE TO THE DRIVE
Follow mounting recommendations described in this document.
Failure to follow these instructions can result in equipment damage.
Step Action
1 Observe the safety regulations in the target country
2 Select the label suitable for the target country
3 Attach the label to the front of the device so that it is clearly visible. Below is the English version. The label can
vary depending on the frame size of the product.
NOTE: Products used in Canada according to CSA C22.2 no.274 must comply with the requirement defined
by the Canadian Advisory council of Electrical Safety (CACES).
It defines that dual language (French and English) safety labeling is required on all products for use in Canada.
To fulfill this requirement, add the French language safety label on the front panel of the product.
50 mm
2 in.
Depending on the conditions in which the drive is to be used, its
installation will require certain precautions and the use of appropriate
accessories.
 Install the drive vertically, at ± 10°.
 Fix it on the mounting surface using M5 screws with captive washer.
 Do not place it close to heating elements.
 Leave sufficient free space so that the air required for cooling purposes
can circulate from the bottom to the top of the drive.
 Free space in front of the drive: 10 mm (0.39 in.) minimum.
The use of washers is recommended with all mounting screws.
100 mm
4 in.
50 mm
2 in.
100 mm
4 in.
ATV212H ATV212W