Install Instructions
Table Of Contents
- Table of Contents
- Safety Information
- About the Book
- Before You Begin
- Steps for Setting Up
- Upstream Protective Device
- Technical Data
- Installation
- Drive mounting generalities
- Specific recommendations for mounting in an enclosure
- Position of the charging LED
- Opening the drive to access terminals
- Wiring recommendations
- Power terminals
- Control terminals and switches
- Installing option card
- Use on an impedance grounded (IT) system
- Electromagnetic compatibility (EMC)
- Checking the Installation
- Recommended branch circuit protection devices
- Maintenance
- Migration ATV21 --> ATV212
20 S1A53832 03/2019
Steps for setting up
1. Check the delivery of the drive
v Check that the part number printed on the label is the same as that on the
purchase order.
v Remove the Altivar from its packaging and check that it has not been damaged
in transit.
2. Check the line voltage compatibility
v Check that the voltage range of the drive is compatible with the
supply voltage (see page 35).
3. Mount the drive vertically
v Mount the drive in accordance with the instructions in
this document (see page 40).
v Install any options required
(see option documentation).
4. Wire the drive (see page 53)
v Connect the line supply and the ground, after
making sure that the power is off.
v Connect the motor, ensuring that its
connections correspond to the voltage.
v Connect the control part.
5. Please refer to the
programming manual.
PROGRAMMING
INSTALLATION
Steps 1 to 4 must be
performed with the power off.