User manual
26
USING MULTIPLE CONTROLLERS IN THE SAME AREA:
When multiple controllers are installed in the same area of transmission, it
is necessary to manually synchronize each controller with it’s camera(s) in
a different group.
To do this:
1. On the controller, select the SIGNAL mode and press OK.
2. Hold down the button for 3 seconds to reach the group option located
in the upper right corner of the screen controller and press OK.
3. Use or buttons to assign a new group to each additional controller
(maximum 5 BLACKBOX
TM
-D) and press OK.
4. Synchronize the cameras to the new group (follow the steps in the
PREPARING THE CAMERA (P.26) and PREPARING THE BLACKBOX
TM
-D
CONTROLLER (p.26) sections.
Setup • Controller (BLACKBOX
TM
-D
)
• Watching on TV:
Allows the user to view or delete the photos directly on a TV.
1. Turn on the controller.
2. Connect the yellow end of the RCA cable supplied into the VIDEO IN of
the TV and the other end into the TV OUT of the controller. The options
are the same as viewing on the screen of the camera (previously
mentioned)
SYNCHRONIZE A NEW CAMERA TO THE CONTROLLER:
Preparing the camera:
1. Set the name of the camera:
• When SETTINGS is selected, choose "Camera ID" and press OK.
• Determine the name of the camera by pressing the or buttons to
change the letter and press OK to go to the next space.
2. Continue changing other parameters of the camera as needed.
3. To enable communication with the controller:
• While still in the SETTINGS menu, select "Wireless" option and press
OK.
• Select "On" and conrm the selection by pressing OK; then on to
return to the previous menu.
4. Select the SIGNAL mode and press OK. The camera searches for the
controller.
Preparing the BLACKBOX
TM
-D controller:
1. Select the SIGNAL mode .
2. Press on "Add new camera" (to see this option, select a blue camera icon
using f or g buttons. The "Sync" icon changes from
red to green in the camera screen when synchronization is
successful.
Note: A camera cannot be synchronized to multiple controllers.
RCA
Notes:
• It’s possible to synchronize up to 10 cameras to a single controller.
• If the name of the camera is changed, it is necessary to resynchronize
the devices by following the steps in the PREPARING THE CAMERA
(P.26) and PREPARING THE CONTROLLER (p.26) sections.
• The "Reset All" option allows to nd the original settings.
• It is possible to easily retrace the BLACKBOX
TM
-D controller with a buzzer
signal by pressing the FN button on the RC-1 remote control. The remote
control must be previously synchronized with the camera, which commu-
nicates with the controller. The remote control (sold separately, p.34)
is part of the product line compatible with the REMOS
TM
technology.
Sync