User manual

23
Setup • Receiver (BLACKBOX
TM
)
Note: In the minute following turning on the receiver, the test light of the
receiver ashes. The rst 8 seconds allows the user to know the battery
status (p.10). Then for the rest of the time, the test light ashes rapidly
to indicate the synchronization period.
Note: After a synchronization or when the test light turns off (after 60
seconds), the receiver can’t be synchronized unless it is turned off and
on again.
MANUALLY SYNCHRONIZING ONE OR MULTIPLE SETS (TINY-W
BF
CAMERA/BLACKBOX
TM
RECEIVER) IN THE SAME PERIMETER
To change the synchronization channel or to install one or many sets
(TINY-W
BF
/BLACKBOX
TM
receiver) in the same area of transmission, it is
necessary to manually synchronize each camera with its receiver on a
different channel.
1. Turn on the rst camera and choose the SIGNAL mode.
2. Turn on the rst BLACKBOX
TM
receiver.
3. Choose the
Channel
1
option on the camera and press OK.
4. Use the  and  buttons to select a channel and press OK.
5. Choose the
Sync
option on the camera and press OK.
6. The camera synchronizes with the powered receiver and the
icon Sync goes from red to green when the synchronization
is complete.
6. Turn off the camera and the corresponding receiver.
7. Repeat these steps for each additional set, up to 9 sets (TINY-W
BF
/BLACK-
BOX
TM
receiver) can be matched in a same perimeter of 250ft.
Sync