User manual
19
Settings • Camera
Remote control (RC-1): (TINY-PLUS, TINY-W
3
) 
(On/Off)
Allows the user to use the RC-1 remote control which works with the RE-
MOS
TM
 wireless technology (sold separately, p.34). The remote control 
allows to activate/deactivate the detection of the camera, to remotely 
take a photo/video in an area of 500 ft and to activate the buzzer signal 
on the BLACKBOX
TM
-D controller in an area of 500ft.
Remote sensor (MS-1): (TINY-PLUS, TINY-W
3
)
(Off/1/2/3/4/5/6/7)
Allows the camera to be triggered wirelessly by one or more MS-1 devices 
through the REMOS
TM
 wireless technology, sold separately (p.35).
IR-Booster: (TINY-PLUS, TINY-W
3
)
(On/Off)
Allows the camera to trigger, up to a distance of 50ft, one or more IR-
BOOSTER infrared lighting devices without the use of an additional trans-
mitter through the REMOS
TM
 wireless technology. Sold separately, p.35.
REPORT
The report mode keeps a record of the last period of use of the camera 
and indicates the battery level (4/4=full). The beginning date corresponds 
with the moment the camera is set to either PHOTO or VIDEO mode. Thus, 
the report is reset when changing modes.
Side sensors:
(On/Off)
When the side sensors are activated, a total of 7 zones are covered. The 
central sensor covers 5 zones. The side detectors are mainly used to pre-
pare the camera so when your target passes through the central sensor, 
the system is already pre-triggered, increasing greatly the reaction time 
of your camera (ideal when the camera is placed near a narrow trail).
  The side sensors require more battery power.
Time lapse:
(Off/30s/1m/3m/5m/15m/30m/1h) 
Allows the camera to take photos at regular preset intervals. For example, 
if the option "5m" is selected in the TIME LAPSE mode, the camera takes 
a photo every 5 minutes during the period of operation (start time and 
stop time) even if there is no detection. This option allows the user to 
obtain photos of game outside the detection range of the camera.
Note: The TIME LAPSE mode only applies in PHOTO mode, not in VIDEO 
mode. When TIME LAPSE mode is selected, the DELAY option and the 
MULTI-SHOT mode are disabled. The photo resolution remains the same 
except for the low resolution which is reduced to 800 x 600.
34’
30’
65’ 
30° 70°40°
Camera
Detection distance (central)
Detection distance
of the side sensors
s: Side sensors
c: Central sensor
 : Detection zone
 : Viewing field
30°: Detection angle of the central sensor
40°: Viewing angle for TINY series cameras
70°: Detection angle including both 
  central and side sensors (2)










