Product Manual

www.spyker.com

5. Remove existing nuts, washers and bolts holding the

left side of the spreader hopper to the frame.

NOTE: Set aside the white washers (B) that you've

removed from your spreader. (Discard the removed

nuts and bolts).

Add the salvaged white washers (B) to each of the two

new bolts (9).

Align the side deector with the holes of the frame and

run the two bolts (9) through the same location of the

spreader, passing through the spreader frame and

deector assembly (as illustrated below).

Secure in place with two nylon lock nuts (7).

Left side

of hopper

6. Loop the spring (10) through the spring bracket

added on Step 4 and the kick bar added on Step 3.

50lb Spreader Spring

uses the Bottom Hole

80lb & 100lb Spreader

Spring uses Top Hole

Assembly