Product Manual

Assembly

1. After removing all the parts from your box, place the

pre-assembled hopper portion in your work area.

Start upside down and facing this direction:

2. Add 1 washer (62) to the wheel axle (31), then slide

on the tire (63) and an additional washer (62).

Secure in place with the Rue Ring Locking Pin (61).

(Seegures2band3cbelow).

3. Add 2 washers (62) to the wheel axle (31). Slide on

the tire (63).

 Iflastwasherdoesnott,removetire&

one of the interior washers.

Lock the wheel in place with the Clevis Pin (65) and

Hair Pin (66).

4. Run two Hex Head bolts (44) through the frame

(See Fig. 4 for alignment). Lower the tubing for the

stand (59) on the bolts and secure in place with two

Nylon Lock Nuts (3).

Tightencompletelywitha7/16”socket&wrench.

Fig. 1

Start with

this side.

Fig. 2

Fig. 3

Fig. 2c

Fig. 4

Fig. 2b

Front