Product Manual

1017628-C Page 16 ©2017 Spyker Spreaders/A Brinly-Hardy Co.
Calibration
Adjusting the Accuway
!
READ BEFORE USING
How to Test for a Uniform Distribution Pattern: ( ...continued from page 15).
9. Review the recorded
weights. Ideally for an
even distribution, LH Pan
1 and RH Pan 1 would
have approximately the
same material. The same
for LH Pan 2 and RH Pan
2, etc.
10. If the spreader pattern is
not even, then adjust the
Accuway according to
these charts and repeat
steps 3-9.
Please adjust in
very small increments,
as the Accuway is
very sensitive.
NOTE: Moving the Accuway plate will shift the material on the spinner. Adjustment is very
sensitive&shouldbedoneinsmallincrementsuntilthespreadpatterniscentered.
Turndial&shiftAccuway
to the back half of the opening.
Turndial&shiftAccuway
to the front half of the opening.
(front)↑
↓(handle)
(front)↑
↓(handle)
Travel
Spread
Pattern
How to
Adjust
the
Accuway
Setting:
HEAVY to the Left HEAVY to the Right
PAN
DISTANCE
FROM
CENTER
WEIGHT
OF
MATERIAL
LH
PAN
7
RH
PAN
1
LH
PAN
3
RH
PAN
5
LH
PAN
5
RH
PAN
3
LH
PAN
1
RH
PAN
7
LH
PAN
6
RH
PAN
2
LH
PAN
2
RH
PAN
6
LH
PAN
4
RH
PAN
4
CENTER
PAN
CHART A