Product Manual

Assembly

9. Adding the Control Lever Stop.

Orientation is very important on this step.

- The Control Lever Stop (73) needs to be centered

over the three holes on the right side of the handle.

(Same side as the On/Off sticker).

- The lip of the the Control Lever Stop (73) needs

to be POINTED OUT & AWAY from the handle

tubing. (See Fig 9b).

Fig. 9b

Fig. 9a

Fig. 9c

- Leave the

center hole

open and run

two hex head

bolts (44) through

the outer two

holes of the Handle

Weldment (41).

Bolts should

also pass

through the

Control Lever

Stop(73)&two

1/4” washers (43).

- Add two Nylon Lock Nuts (3) on the ends of the

Bolt (44). Verify the Control Lever Stop (73) is

centered (see Fig 9a) before tightening the Nuts

(3) completely, securing everything in place.

10. Adding the linkage bar.

Orientation is very important on this step.

The Linkage (51) is a long, thin bar that connects

the dial and the Control Lever.

Slide the Linkage (51) into the Linkage Assembly (7)

from the side from left to right at a low angle, then

lift it up toward the handle.

(See Fig. 10b)

Fig. 10a

Fig. 10b