Product Manual
1017628-C Page 10 ©2017 Spyker Spreaders/A Brinly-Hardy Co.
Tighten the hardware from steps 5 & 6
completely with a 1/2” socket & wrench.
Assembly
FLIP
SPREADER
OVER
8. Setting the spreader handle height.
Determine the angle / height you will want your
handle. (At the highest point, the handle will be 36”
off the ground. At the lowest point, the handle will
be 32” off the ground).
5. Align the two holes of the Lower Handle (52) with
the two holes of the outer, rear edges of the Frame
(59). Place one of the Lock Washers with teeth (76)
between the square hole of the Handle (52) and the
curved slot on the Frame (59).
Starting from the inside of the Frame, run a Carriage
Bolt (56) through the curved slot of the Frame (59).
The Carriage Bolt will also pass through the square
hole of the Lower Handle (52) and the end will be
facing out.
Loosely secure with a washer (54) and a Nylon Lock
Nut (53). Usea1/2”Socket&Wrench. Repeat on the
other side.
7. Add the Handle Weldment (41) by lining it up on the
Lower Handle tubing from step 6.
Secure the Handle in place by running four Hex
Head Bolts (46) through the two handle ends from
the outside. Tighten with four Nylon Lock Nuts (3)
from the inside of the Lower handle (52).
Tightenwitha7/16”socket&wrench.
Fig. 8
41
52
46
46
3
Fig. 8
SHORTEST SETTING
TALLEST SETTING
6. Add one washer (54) to a hex head bolt (55). Starting
from the outside edge, run the bolt through the circular
holes of the Lower Handle (52) & Frame (59), then
loosely secure with another washer (54) & a Nylon
Lock Nut (53).
Usea1/2”Socket&Wrench.Repeat on the other side.
Do NOT tighten (yet).
52
Fig. 5
53
55
54
54
59
Do NOT tighten (yet).
53
56
59
54
52
76
Fig. 6