WITH EYE USER MANUAL
WITH EYE TABLE OF CONTENTS IMPORTANT SAFETY GUIDELINES 1 OPERATION GUIDE / START UP 2 COMPRESSED AIR TANK WARNINGS 3 INSTALLING COMPRESSED AIR TANK 4 PROPER USE OF BARREL BLOCKING DEVICE 4 BATTERY INSTALLATION 4-5 BATTERY CHARGING 5 ELECTRONICS & SETTINGS 5-7 TRIGGER ADJUSTMENT 7 VELOCITY ADJUSTMENT 7-8 C/A ON/OFF ADAPTER 8 REGULATOR ADJUSTMENT 9 DISASSEMBLE / REASSEMBLE AND CLEANING OF REAR INTERNALS
IMPORTANT SAFETY GUIDELINES OPERATION GUIDE / START UP WARNING: Always keep the marker powered OFF or on SAFE until you are ready to fire. WARNING • This paintball marker is NOT a toy. It can cause serious injury or death. • Kingman recommends that the customer be at least 18 years of age to purchase this product. • Read this manual and air tank warnings before using this product. • Any modifications or tampering of original factory parts will void all warranties and liabilities from Kingman.
COMPRESSED AIR TANK WARNINGS INSTALLING A COMPRESSED AIR TANK Firmly screw the Compressed Air Tank clockwise into the markers C/A On/Off adapter (#ASA020). HELPFUL TIP: Before installing a Compressed Air Tank, make sure that the tank is full and that it has a urethane bottle on the top of the valve to prevent air leaks. IMPORTANT: You should never need to use any hand tool to attach a Compressed Air Tank to the C/A On/Off adapter.
CIRCUIT BOARD SETTINGS AND LED COLOR FUNCTIONS WARNING • Spyder Electronic Markers are not water resistant. • Extreme moisture can cause serious damage to any Spyder Electronic Marker. • Always clean any dirt or paint inside the markers electronics. • Never attempt to modify the electronics circuitry, doing so will VOID all electronic warranties and liabilities from Kingman. BATTERY CHARGING SPYDER LED A/C CHARGER INSTRUCTIONS #JE1029 To charge a Spyder 9.
To enter a new Trigger Debounce Setting, press the Mode Button to select the new Trigger Debounce Setting. For example, to set the Trigger Debounce to the least sensitive setting, a Level Five (5), you must press the Mode Button five (5) times. After the Trigger Debounce setting has been selected, turn the marker off by pressing and holding the Power Button.
REGULATOR ADJUSTMENT Increase Velocity Decrease Velocity #SCR026 #REG006 WARNING: Never at any time should you attempt to unscrew the Vertical Regulator while the marker is pressurized. Doing so can cause serious injury or death. The RSX is equipped with a Vertical Inline Regulator located in front of the markers trigger frame. Once a Compressed Air tank has been installed and tank valve is opened by turning the C/A On/Off adapter knob clockwise, the marker is potentially capable and ready to fire.
before attempting to un-jam the marker. Remove all paintballs and the loader from the feed neck. Have the barrel removed from the receiver to allow the paintball(s) to exit. With enough force tension on the Cocking Knob, pull back to release the Delrin bolt from the jammed position. Another method is to use a “Straight Shot Squeegee” or the end of a wood dowel rod; push against the face of the Delrin bolt with enough force to release the jammed bolt.
TECH TIP: Before loosening the rear Trigger Frame Screw place your finger in front of the Striker Plug, so the internal parts don’t spring outward if the Delrin Bolt is in the cocked position. TECH TIP: Notice how the Striker Bolt Mini is placed in the Receiver before removed to ease re-entry. STEP 5 Loosen the Vertical Screw counter-clockwise to allow the Vertical Adapter w/Gage to release from the Receiver. STEP 6 Loosen the Valve Body Screw counter-clockwise to allow access to the Valve Body.
RSX PARTS LIST 15 ASA012 ASA013 ASA017 ASA018 ASA020 BAR010 BAR021 BLS021 BLS002 31202* ELM001* ELM002* ELM004* ELM005* FND001 FND002 FND021 GAG002 GRP001 GRP002* HSE008 HSF004 HSF009 ITP001 ITP002 ITP003 ITP004 JE1015* JE1029* LPC021 ORG001 ORG002 ORG003 ORG005 ORG006* ORG008 ORG016* ORG017* ORG018 ORG021 ORG022 PAK001* C/A On/Off Depressing Pin C/A On/Off Retaining Screw (f) C/A On/Off Adapter Knob (matte black) C/A On/Off 1/8 Hose Plug C/A On/Off Adapter (matte black) 12” 2PCS Barrel 12” Barrel Tip (m
