TROUBLESHOOTING ONE OR MORE OF THE FOLLOWING MAY CAUSE RECOCKING RELATED PROBLEMS: a. The pressure in the tank is too low or too high. b. Need lubrication. (See step 6 in OPERATION GUIDE) c. #19A (striker o-ring) is damaged. Replace with new Kingman or Kingman-approved o-ring. (Note: the #19A O-ring cannot be substituted by a tank o-ring or a #9 o-ring). d. Need to clean barrel and upper chamber of the receiver. e. Paintball may be defective. (i.e. expired, change shape) f.
removed. 8) Lubricate o-rings (#9) and (#19A) with a few drops of paintball oil only. 9) Re-assemble parts back into the marker. Note: when putting the Venturi-Cocking Bolt and striker back into the marker, you will need to apply pressure behind the bolt while Pushing the movable disc of the coil set (#JB18C) forward to the limit at the same time (right now the battery side grip must be opened). This will allow the bolt and striker to be properly installed back into the receiver.
over a week. Life Of Battery With the qualified Charger, and in normal use conditions, about 700-1000 charge-recharge cycles can be expected. This can be varied depending on the type of use. GENERAL MAINTENANCE (1) Use the compressed air to clean the coil set (part No. #JE18C) to keep it's best performance after every use. (2) Beside (1) cleaning should only be performed on the exterior of the IMAGINE trigger frame. Never submerge the IMAGINE trigger frame in any type of liquid for any reason.
Press, Push and hold the button on the back of the trigger frame for over 2 seconds, then release the button. Click, push and then release the button. The duration should be less than 1 second. Notes: During the interval of R.O.F. Adjustment, the SAFETY will be turned ON automatically, that is, the trigger will be disabled on this interval. The SAFETY will be turned OFF automatically at the end of R.O.F. Adjustment, then the trigger will be functioning normally.
