Manual

INSTALLING / REMOVING A PAINTBALL LOADER

HELPFUL TIP: The Vertical Clamping Feed Neck is not attached to the Receiver when purchased new.

Attach a gravity or electronic paintball loader to the markers Feed Neck and tighten the Feed Neck Screw. Use only

(.68 cal) paintballs through a paintball loader.

Loosen the Feed Neck Clamping Screw and remove the gravity or electronic paintball loader. When removing the

loader make sure to remove all paintballs. CAUTION: There may be a paintball(s) in the Markers breach; take a couple

of shots in a safe direction to make sure the Barrel and Receiver are empty.

LOADING PAINTBALLS IN THE MAGAZINE

IMPORTANT: The Barrel must be installed before loading

the Magazine or Paintball Loader.

IMPORTANT: Always have the Marker on SAFE MODE

until you are ready to operate.

IMPORTANT: Storing paintballs in a temperature of 59°

F (15°C) or below will affect the quality and performance

of the paintballs.

IMPORTANT: The Magazine should be clean and free of

any shell fragment or dirt before loading paintballs.

WARNING: DO NOT attempt to Freeze any Paintballs.

STEP 1 Slide the ball pusher towards the bottom of the

Magazine and turn to the left to place the guide pin in the

locked position.

STEP 2 Load only 9 Paintballs (.68 Cal.) or 9 First

Strike Paintballs. NOTE: First Strike Paintballs can only be loaded in a specific direction in the First Strike Capable

(FSC) 9 round Straight Magazine. HELPFUL TIP: The Fin of the First Strike Paintball is facing towards the Receiver

and the Rounded Body of the First Strike Paintball is facing towards the Barrel. NEVER mix First Strike™ Paintballs

and (.68cal) Paintballs inside a Straight Magazine.

STEP 3 Follow the guided line to insert the Magazine straight into the Trigger Housing until it snaps into position.

STEP 4 Turn the ball pusher pin right to the un-locked position.

IMPORTANT: If the ball pusher pin is not released, the spring will not push the paintballs into the Markers breach.

RELEASING THE MAGAZINE

Push the Magazine release button located on the right side of the Markers handle. This will allow the Magazine to

slide out the handle. NOTE: Never take apart the Magazine release button unless the Magazine does not release

from the trigger frame.

IMPORTANT: NEVER slam the Magazine into the receiver, excessive force inserting the Magazine will push a

paintball pass the ball detents and roll out the barrel.

NOTE: Do not store Magazine (s) loaded with paintballs for an extended period of time as the pressure from the

Magazine spring will cause the paintballs to de-form and not shoot properly.

HELPFUL TIP: Older paintballs left for a period of time are not recommended for use or you will experience

premature paintball breakage and poor accuracy.