Manual
14
INSTALLING / REMOVING THE SOPMOD
STOCK
Place the SOPMOD Stock in the top breach of the Receiver
behind the FS Venturi Bolt. Once the SOPMOD Stock is in place
secure the Stock with the set screw provided, then tighten with
the Allen wrench.
To adjust the length of the SOPMOD Stock press and hold the
Lever for adjustment. Once the Lever is released this will lock
into position.
Loosen the set screw on the right side of the Receiver with
the Allen wrench. Then remove the SOPMOD Stock out the
top breach of the Receiver. HELPFUL TIP: The SOPMOD
Stock must be removed if intended to clean the marker. (SEE
DISASSEMBLE/REASSEMBLE AND CLEANING OR REAR
INTERNALS).
VELOCITY ADJUSTMENT INCREASE / DECREASE
To INCREASE your velocity FPS (Feet Per Second) using
the Allen wrench turn the Velocity Adjuster / Spring Guide
clockwise.
To DECREASE your velocity FPS (Feet Per Second) using
the Allen wrench turn the Velocity Adjuster / Spring Guide
counter-clockwise.
NOTE: The velocity of this paintball Marker ranges from
approximately 220 - 300 feet per second (fps). Velocities
will fluctuate or vary due to paintball size, climate condition,
altitude, type of air source and variance in spring tension from
manufacturing.
WARNING:
• The recommended Velocity speed should be no greater
than 300 fps. Not doing so can cause serious injury if
the Velocity is dangerously high.
• Paintball markers are not intended to shoot any person
less than 30 feet.
• Never point a loaded marker at any person who is not wearing the proper face protection.
• Never at any point should you look down the barrel, whether the marker is loaded or not.
• Using a paintball marker outside a non designated paintball field can be illegal, and is subject to law
enforcement penalties if property damage is caused by the user.
A JAMMED PAINTBALL
In the event of a paintball break and the FS Venturi Bolt jams, follow these steps to help un-jam the Marker. The
Markers breach is located where the barrel starts to thread in the Receiver and underneath the Markers feed neck.
Before attempting to un-jam the FS Venturi Bolt you should always have your Goggles or Safety Glasses on. Make
sure the Marker is in the SAFE MODE position before attempting to un-jam the FS Venturi Bolt. Remove the CO2/
Compressed Air Tank before attempting to un-jam the Marker. Remove all paintballs from the Magazine and Force
Feed Paintball Loader. Have the barrel removed from the Receiver to allow the paintball(s) to exit. With enough
force on the AR15 Charging Handle, pull back to release the FS Venturi Bolt from the jammed position. Another
method is to use a “Straight Shot Squeegee” or the end of a wood dowel rod; push against the face of the FS Venturi
Bolt with enough force to release the jammed Bolt. Always clean the paint from the breach and barrel to enhance the
performance of your Marker.
Decrease
Velocity
Increase
Velocity
STP089
VTA089