Manual

English
11
LEAP 3 CIRCUIT BOARD w/C.A.M.D. STINGS
SAFE – Red LED
SEMI – Green LED
3 Burst – Blue LED
6 Burst – Blue LED
AUTO – Orange LED
BATTERY ICON – Yellow LED (Solid LED = Good, Flashing LED = Low)
2 BUTTON ACCS OPERATIONS
Press and release the Upper “Power” Button to turn the Marker “On”. The C.A.M.D. Board
will display the Red “Safe” indicator “On” meaning that the Marker is in safety mode and will
not allow the Marker to shoot. The default firing mode is Semi Auto and the Green “Semi”
indicator will be displayed as the Marker firing mode.
To turn the safety “Off” press and release the Lower “Mode” Button and the Red “Safe”
indicator will turn off, the Marker is now capable of firing in Semi Auto. To turn the safety back
“On” press and release the Lower “Mode” Button again.
To turn the Power “Off” press and hold the Power Button until all C.A.M.D. LED indicator powers down completely.
CHANGING MOD
To change the firing mode, Press and hold the Lower “Mode” Button until the firing mode indicator on the C.A.M.D.
Board will start flashing. While the indicator is flashing press and release the Lower “Mode” Button to scroll through
the mode setting. When the desired firing mode has been selected, press and hold the Lower “Mode” Button until
the indicator stops flashing. The Marker will now operate in the firing mode that has been selected. The Red “Safe”
indicator will remain “On”, to turn the safety “Off” press and release the Lower “Mode” Button and the Red “Safe”
indicator will turn “Off”, the Marker is now capable of firing in the selected mode.
IMPORTANT: The safety may be enabled in any mode by pressing and releasing the Lower “Mode” Button, the Red
“Safe” LED indicator will turn on and keep the Marker from accidentally shooting while the Power is “On”.
FIRING MODE LOCK
To lock the operations of the Marker in Semi-Auto Mode remove the lock switch from the circuit board while the
Power is “Off” this will default the Marker operation and shoot in Semi-Auto Mode Only.
To lock the operation in 3 Burst Mode turn the Marker Power “ON”, select 3 Burst on the C.A.M.D. Board indicator,
remove the tournament lock switch from the circuit board to lock in 3 Burst Mode. NOTE: Following the same steps
on selecting the 3 Burst Mode will allow you to lock the Marker operation in 6 Burst or Auto Mode. NOTE: Use
the lock switch when the playing field requires it. NOTE: Semi-Auto Mode maybe the only allowable Firing Mode
permitted in your country. Check with your local officials regarding this application. For example select European
countries, Australia and New Zealand are restricted to use Semi-Auto Model ONLY.
BATTERY POWER INDITOR
If the battery power drops below 8.5 volts, the battery icon on the C.A.M.D. Board will start flashing indicating a low
power supply, it is time to replace the battery or if you are using a Spyder 9.6 Volt Rechargeable Battery, then it is
time for a recharge. NOTE: The low battery indicator icon will only flash while the Power is “On”.
SLEEP MODE
The LEAP 3 Circuit Board comes with this feature to improve Battery Life and the board will power down after 20
minutes of inactivity.
WARNING
• Spyder Electronic Markers are not water resistant.
• Extreme moisture can cause serious damage to any Spyder Electronic Marker.
• Always clean any dirt or paint inside the Markers electronics.
• Never attempt to modify the electronics circuitry, doing so will VOID all electronic warranties and liabilities
from Spyder.