Manual

English

INSTALLING A CO2 / COMPRESSED AIR TANK

Firmly screw the CO2 / Compressed Air Tank clockwise into the markers C/A Adapter. HELPFUL TIP: Before

installing a CO2 / Compressed Air Tank, make sure that the tank is full and that it has a urethane bottle O-ring on

the top of the valve to prevent air leaks. IMPORTANT: You should never need to use any hand tool to attach a CO2 /

Compressed Air Tank to the C/A Adapter.

REMOVING A CO2 / COMPRESSED AIR TANK

Firmly unscrew the CO2 / Compressed Air Tank by turning the tank counter-clockwise until it comes out of the C/A

Adapter. HELPFUL TIP: After firing the marker, you should ALWAYS remove the CO2 / Compressed Air Tank before

storing. When the tank is being removed, excess air will release from the C/A Adapter. CAUTION: Never expose any

skin to the C/A Adapters bleed hole when removing the tank. This is to avoid the risk of getting skin burn from the

escaping GAS.

IMPORTANT: You should never need to use any hand tool to detach a CO2 / Compressed Air Tank from the C/A

Adapter. If you cannot remove a tank by hand please see a certified air smith for assistance.

E-MR5 BARREL INSTALL / REMOVE / SETUP

To install the barrel you must lineup the center arrow marked on the barrel to the arrow marked on the Front Shroud

Base (see figure A) once lineup then insert the barrel.

To Set up for “Magazine” feeding, turn the barrel counterclockwise making sure the arrow marking on the barrel (M )

is line up with the arrow marked on the Front Shroud Base (see figure B).

To set up for the “Loader” feeding, turn the barrel clockwise making sure the arrow marking on the barrel (L ) is line

up with the arrow marked on the Front Shroud Base (see figure C).

Removing the barrel you must lineup the center arrow marked on the barrel to the arrow marked on the Front Shroud

Base (see figure D) once lineup then pull the barrel out.

PROPER USE OF YOUR BARREL BLOCKING DEVICE

A Barrel Blocking Device or “BBD” is an essential part of your paintball safety equipment. The Barrel Blocking

Device is designed to stop a paintball from exiting a paintball marker accidentally. Improper use of the Barrel

Blocking Device will not provide protection.

BARREL SOCK/BAG TYPE DEVICE

Place the bag/sock part of the Barrel Blocking Device over the end of your barrel and wrap the elastic cord around

the back end of your marker. Adjust the length of the elastic cord to make sure your Barrel Blocking Device fits

securely over your markers barrel. NOTE: If the elastic cord is too long you can tie a couple of knots around the cord

to shorten its length.