Manual

11
Eko™ CUP SEAL REMOVAL
SCR016
LPC085
SPR024
ITP023
ITP026
STEP BY STEP Eko™ CUP SEAL ACCESS
The following steps will provide easy access to the Eko™ Cup Seal. The sign of a worn out Eko™ Cup Seal is the
presence of CO2 / Compressed Air leaking down the barrel.
STEP 1 Loosen the Vertical Screw that holds the Front Plug in front of the Reciever.
STEP 2 Slide the Front Plug out of the Receiver.
STEP 3 Once the Front Plug has been removed the Valve Spring, Eko™ Valve Pin, Eko™ Cup Seal Guide and Eko™
Cup Seal will be attached.
STEP 4 Detach the Valve Spring from the Front Plug, and then unscrew the Eko™ Cup Seal from the Eko™ Valve
Pin. Replace the Eko™ Cup Seal with a new one supplied in the Spare Parts Kit.
STEP 5 Detach the Valve Spring from the Vertical Adapter, and then unscrew the Eko™ Cup Seal from the Eko™
Valve Pin. Replace the Eko™ Cup Seal with a new one supplied in the Spare Parts Kit.
Once these steps have been completed, replace the damaged Eko™ Cup Seal and reassembly all parts back in the
Receiver. HELPFUL TIP: Please note how the parts are removed for easy reassembly.
CAUTION: Use the proper Allen wrenches to fasten all screws and never apply more force than necessary.
IMPORTANT: Always remove the Air Tank before any disassembly of your marker. Do not remove the Eko™ Valve Body
unless specific Eko™ Valve Body repairs are needed. Do not remove the Eko™ Valve Body with a screwdriver as it will
damage the Eko™ Valve Body Lip and cause air leaks. NOTE: The Eko™ Valve Body Screw screw must be removed prior to
taking out the Eko™ Valve Body.
Part Names and Numbers describe in this section:
Vertical Screw (#SCR016)
Eko™ Cup Seal (#ITP023)
Eko™ Valve Pin (#ITP026)
Valve Spring(#SPR024)
Front Plug (#LPC085)