Manual

10
English
Quick Clean Disassemble
Lift upward on the Top Cocking Knob to disconnect the Delrin Bolt from the Striker Bolt. This will allow the Delrin
Bolt to slide out from the rear of the Receiver. HELPFUL TIP: Removing the Delrin Bolt from the Receiver will allow
easy access to clean with a squeegee. NOTE: Make sure the hole on the Striker Bolt is facing upright when looking
thru the Receiver. This will allow the Top Cocking Pin to correctly fasten with the Striker Bolt.
IMPORTANT: The air passage hole located in the middle of the Delrin Bolt should always be facing downward when
reinstalling. If the Delrin Bolt is not installed correctly, paintballs will not exit out of the barrel normally.
Disassemble Rear Internals
STEP 1 Lift upward on the Top Cocking Knob to disconnect the Delrin Bolt from the Striker Bolt. This will allow the
Delrin Bolt to slide out from the rear of the Receiver
STEP 2 With a firm grip on the Striker Plug, turn the Striker Plug counter-clockwise to remove. This will allow all
internal parts such as the Velocity Adjuster & Spring Guide, Striker Spring, Striker Buffer and Striker Bolt to slide
from the rear of the Receiver. NOTE: Remove the Striker Plug only with the marker in the un-cocked position. This
will prevent the internals from springing out because the Striker Spring is compressed. HELPFUL TIP: Placing your
finger behind the Striker Plug before removing this will prevent the markers internals from springing out.
STEP 3 Remove items in order; Striker Plug w/Velocity Adjuster, Striker Spring and Striker Buffer.
STEP 4 Slide the Striker Bolt out of the rear of the Receiver. HELPFUL TIP: When the internals are removed it
would be wise to clean any dirt or paint from the inside of the Receiver with a squeegee and wipe the Delrin Bolt
clean with a rag or paper towel. Apply some paintball gun oil on Striker O-ring periodically.
IMPORTANT: It is not necessary to disassemble the rear internals for basic maintenance unless the Striker O-ring
needs to be replaced.
Reassemble Rear Internals
STEP 1 Reinsert the Striker Bolt with Striker O-ring facing toward the front of the marker with the flat spot of the
Striker Bolt facing down. NOTE: Having the Power Switch ON will ease reentry of the Striker Bolt. Apply thumb
pressure behind the Bolt and at the same time pull on the Trigger. Repeat this process until the Bolt is fully inserted.
NOTE: The hole on the Striker Bolt should be facing upright when looking thru the Receiver. NOTE: The images
above display the Delrin Bolt “connected” to and “disconnected” from the Striker Bolt.
STEP 2 Insert the Striker Buffer flush with the receiver and place the Striker Spring thru the Striker Buffer.
STEP 3 Tighten firmly the Striker Plug w/Velocity Adjuster & Spring Guide to the rear of the Receiver.
STEP 4 Insert the Delrin Bolt thru the rear of the Receiver with the Top Cocking Pin. Press downward on the Top
Cocking Pin to gain entry with the Striker Bolt. NOTE: If the Striker Bolt hole is not aligned upright, the Top Cocking
Pin will not fasten correctly.
WARNING
Before/after use of the marker, make sure to fasten all screws. Screws may become loose due to vibration. Loose
screws can be dangerous and cause injury.
To assure that the marker is assembled properly, follow the schematic drawing or position parts in order during
disassembly. Parts assembled backwards or improper parts installed will/can cause the marker to malfunction.
DISCONNECTEDCONNECTED