Manual

SCR016
SCR045
SCR035
Swivel End
Reassemble Rear Internals
STEP 1 Insert the Striker Bolt thru the rear of the Receiver with the o-ring facing towards the front of the marker.
NOTE: When inserting the Striker Bolt, apply pressure behind the Striker Bolt and at the same time pull on the
Trigger to allow entry of the Striker Bolt. NOTE: The hole on the Striker Bolt should be facing upright when looking
thru the Receiver. This will allow the Top Cocking Knob to correctly fasten with the Striker Bolt.
STEP 2 Apply thumb pressure on the Striker Bolt or Venturi Bolt, pull the trigger to allow the Striker and Venturi
Bolt to rest halfway inside the Receiver. Screw on the Cocking Knob onto the Venturi Bolt and while push on the
Cocking Knob forward, pull the trigger again. The Venturi Bolt and Striker Bolt are now in its fully rested position.
STEP 3 Place the Striker Plug w / Velocity Adjuster & Spring Guide to the rear of the Receiver.
STEP 4 Insert the Disconnect Pin to secure the Striker Plug in place. WARNING: Before/after use of the Marker,
make sure to fasten all screws. Screws may become loose due to vibration. Loose screws can be dangerous and
cause injury.
To assure marker is assembled properly, follow the schematic drawing or position parts in order during disassembly.
Parts assembled backwards or improper parts installed will / can cause the marker to malfunction.
WARNING
Never attempt to remove the markers internals while the CO2 / Compressed Air Tank is attached. Make sure to
remove all paintballs and loader before disassembling the marker.
13
BARREL SHROUD REMOVAL
STEP 1 Using a 1/2inch or 13mm open end or and adjusted wrench loosen the Swivel End of the hose.
STEP 2 Remove the Three Screws that hold the Trigger Housing to the Receiver. One the Screw is
located at the rear of the Receiver (#SCR016). The other Two additional Screws are on the Left and
Right side of the Trigger Housing (#SCR035).
STEP 3 Once the Trigger Housing is removed from the Receiver loosen all of the Six Screws from
the Shroud. This will allow the Shroud to split in half. NOTE: Fours Screws are identical M4 x 14
(#SCR045) and the other Two are M4 x 12 (#SCR035).
HELPFUL TIP: Please note how the parts are removed for easy reassembly.