Manual

11
HOW TO CLEAN THE MARKER
DANGER: Do not look down the Marker barrel. Always wear goggles specifically designed for paintball use while
working on your paintball Marker.
IMPORTANT: Always have the Marker on SAFE MODE before disassembly. Remove all paintballs and air source
from the Marker before performing any maintenance.
HELPFUL TIP: Follow these steps to help clean/remove Marker parts should in the event of a paintball break.
A JAMMED PAINTBALL
In the event of a paintball break and the Venturi Bolt jams, follow these steps to help un-jam the Marker. The Markers
breach is located where the barrel starts to thread in the Receiver and underneath the Markers feed neck. Before
attempting to un-jam the Venturi Bolt you should always have your Goggles or Safety Glasses on. Make sure the
Marker is in the SAFE MODE position before attempting to un-jam the Venturi Bolt. Remove the CO2/Compressed
Air Tank before attempting to un-jam the Marker. Remove all paintballs from the Magazine and Loader. Have the
barrel removed from the Receiver to allow the paintball(s) to exit. With enough force on the Cocking Knob, pull back
to release the Venturi Bolt from the jammed position. Another method is to use a “Straight Shot Squeegee” or the
end of a wood dowel rod; push against the face of the Venturi Bolt with enough force to release the jammed Bolt.
Always clean the paint from the breach and barrel to enhance the performance of your Marker.
DANGER: Never look down the barrel of the Marker when loaded or unloaded. Remove the attached CO2/
Compressed Air Tank before attempting to un-jam the Venturi Bolt. NOTE: Never use a metal rod or screwdriver as a
tool to push on the Venturi Bolt, anything metal will scratch and damage the inside of the Marker.
To INCREASE your velocity FPS (Feet Per Second)
using the Allen wrench turn the Velocity Adjuster / Spring
Guide clockwise.
To DECREASE your velocity FPS (Feet Per Second)
using the Allen wrench turn the Velocity Adjuster / Spring
Guidev counter-clockwise.
NOTE: The velocity of this paintball Marker ranges from
approximately 220 - 300 feet per second (fps). Velocities
will fluctuate or vary due to paintball size, climate
condition, altitude, type of air source and variance in
spring tension from manufacturing.
VELOCITY ADJUSTMENT INCREASE / DECREASE
Decrease Velocity
Increase Velocity
VTA089
STP089
WARNING
• The recommended Velocity speed should be no greater than 300 fps. Not doing so can cause serious injury if
the Velocity is dangerously high.
• Paintball markers are not intended to shoot any person less than 30 feet.
• Never point a loaded marker at any person who is not wearing the proper face protection.
• Never at any point should you look down the barrel, whether the marker is loaded or not.
• Using a paintball marker outside a non designated paintball field can be illegal, and is subject to law enforcement
penalties if property damage is caused by the user.