Manual

Place the Shoulder Stock in the top breach of the Receiver behind
the Venturi Bolt. Once the Shoulder Stock is in place secure the
Stock with the set screw provided, then tighten with the Allen
wrench.
To adjust the length of the Shoulder Stock press and hold the Lever
for adjustment. Once the Lever is released this will lock into position.
Loosen the set screw on the right side of the Receiver with the Allen
wrench. Then remove the Shoulder Stock out the top breach of the
Receiver. HELPFUL TIP: The Shoulder Stock must be removed if
intended to clean the marker. (SEE DISASSEMBLE/REASSEMBLE
AND CLEANING OR REAR INTERNALS).
INSTALLING / REMOVING A SHOULDER STOCK
English
10
IMPORTANT: The Barrel must be installed
IMPORTANT: Always have the marker on SAFE
MODE until you are ready to operate.
IMPORTANT: Storing paintballs in a temperature
of 59° F (15°C) or below will affect the quality and
performance of the paintballs.
IMPORTANT: The magazine should be clean and free
of any shell fragment or dirt before loading paintballs.
WARNING: DO NOT freeze the paintballs.
LOADING PAINTBALLS IN THE MAGAZINE
STEP 1 Slide the ball pusher towards the bottom of
the magazine and turn to the left to place the guide
pin in the locked position.
STEP 2 Load only 10 Paintballs (.68 Cal.).
STEP 3 Follow the guided line to insert the Magazine
straight into the Trigger Housing until it snaps into
position.
STEP 4 Turn the ball pusher pin right to the un-
locked position.
IMPORTANT: If the ball pusher pin is not released,
the spring will not push the paintballs into the markers
breach.
RELEASING THE MAGAZINE
Push the magazine release button located on the right side of the markers handle. This will allow the magazine to slide
out the handle. NOTE: Never take apart the magazine release button unless the magazine does not release from the
trigger frame.
IMPORTANT: NEVER slam the magazine into the receiver, excessive force inserting the magazine will push a paintball
pass the ball detents and roll out the barrel.
NOTE: Do not store magazine (s) loaded with paintballs for an extended period of time as the pressure from the
magazine spring will cause the paintballs to de-form and not shoot properly.
HELPFUL TIP: Older paintballs left for a period of time are not recommended for use or you will experience premature
paintball breakage and poor accuracy.
before loading the Magazine or Paintball Loader.