Manual

INSTALLING A CO2 / COMPRESSED AIR TANK

Firmly screw the CO2 / Compressed Air Tank clockwise into the markers C/A Adapter. HELPFUL TIP: Before

installing a CO2 / Compressed Air Tank, make sure that the tank is full and that it has a urethane bottle O-ring on the

top of the valve to prevent air leaks. IMPORTANT: You should never need to use any hand tool to attach a CO2 /

Compressed Air Tank to the C/A Adapter.

REMOVING A CO2 / COMPRESSED AIR TANK

Firmly unscrew the CO2 / Compressed Air Tank by turning the tank counter-clockwise until it comes out of the C/A

Adapter. HELPFUL TIP: After ﬁring the marker, you should ALWAYS remove the CO2 / Compressed Air Tank before

storing. When the tank is being removed, excess air will release from the C/A Adapter. CAUTION: Never expose any

skin to the C/A Adapters bleed hole when removing the tank. This is to avoid the risk of getting skin burn from the

escaping GAS.

IMPORTANT: You should never need to use any hand tool to detach a CO2 / Compressed Air Tank from the C/A

Adapter. If you cannot remove a tank by hand please see a certiﬁed airsmith for assistance.

Attach an electronic or gravity paintball loader to the

Markers Feed Neck and tighten the set screw. Only use .68

caliber paintballs through the loader.

Loosen the Feed Neck set screw and remove the electronic

or gravity paintball loader. When removing the loader make

sure to remove all paintballs. CAUTION: There may be

paintballs in the Markers breach; take a couple of shots in

a safe direction to make sure the Barrel and Receiver are

empty.

Loosen both Locking Screws from the Carrying Handle Sight.

Place the Carrying Handle Sight to ﬁt above the Picatinny Body Rail. Make sure to align the Locking Plate with the

Carry Handle Sight. Then Fasten both Locking Screws. NOTE: The Carrying Handle Sight adjusting wheel should be

on the Right side and at the rear of the Receiver.

INSTALLING / REMOVING A PAINTBALL LOADER

INSTALLING CARRYING HANDLE W/SIGHT

IMPORTANT: The Barrel must be installed before loading

the Magazine or Paintball Loader.