Manual

14
AIR LEAKS
IMPORTANT: Always remove the air tank and paintballs before any disassembly of the marker.
Air leaking from the Front Plug means the O-ring (#ORG002) will need to be oiled or replaced.
Air leaking from the Vertical Adapter means the O-ring (#ORG023) will need to be oiled or replaced.
Air leaking down the barrel is usually caused by a worn or damaged cup seal (#ITP012). (see Cup Seal
Removal) should the cup seal need to be exchanged.
Never remove Valve Body (#ITP018) unless specic repairs are needed.
A nick or scratch on the lip of the Valve Body can cause an internal air leak (see Cup Seal Removal). The Valve
Body may need to be replaced.
Air leaking thru the Receiver and out of the Trigger Frame would indicate the Valve Body O-rings (#ORG002)
will need to be replaced.
If air is leaking thru the opposite end of the hose ttings, please check the following:
The female end of the hose must have a plastic washer (#HSF004) installed inside the hose collar and be
tightened properly.
IMPORTANT: The hose line supplied has metric female ends. This will not install into American 1/8” (NPT) threaded
ttings. If installed incorrectly, it is possible to damage the attachment ttings and hose line.
HELPFUL TIP: To assure marker is assembled properly, follow the schematic drawing or position parts in order
during disassembly. Parts assembled backwards or improper parts installed will / can cause the marker to
malfunction.
•
•
•
•
•
•
•
•
English