Manual
4
REMOVING A CO2 / COMPRESSED AIR TANK
Firmly unscrew the CO2 / Compressed Air Tank by turning the tank counter-clockwise until it comes out of the C/A
Adapter. HELPFUL TIP: After ring the marker, you should ALWAYS remove the CO2 / Compressed Air Tank before
storing. When the tank is being removed, excess air will release from the C/A Adapter (#ASA007 or #ASA025)
CAUTION: Never expose any skin to the C/A Adapters bleed hole when removing the tank. This is to avoid the risk of
getting skin burn from the escaping GAS.
IMPORTANT: You should never need to use any hand tool to detach a CO2 / Compressed Air Tank from the C/A
Adapter. If you cannot remove a tank by hand please see a certied airsmith for assistance.
PROPER USE OF YOUR BARREL BLOCKING DEVICE
A Barrel Blocking Device or “BBD” is an essential part of your paintball safety equipment. The Barrel Blocking Device
is designed to stop a paintball from exiting a paintball marker accidentally. Improper use of the Barrel Blocking Device
will render this device useless.
BARREL SOCK/BAG TYPE DEVICE
Place the bag/sock part of the Barrel Blocking Device over the end of your barrel and wrap the elastic cord around the
back end of your marker.
Adjust the length of the elastic cord to make sure your Barrel Blocking Device ts securely over your markers barrel.
NOTE: If the elastic cord is too long you can tie a couple of knots around the cord to shorten its length.
BARREL PLUG TYPE DEVICE
Insert the barrel plug securely into the end of your markers barrel before proceeding to load paintballs and screwing in
your tank to your marker.
The barrel plug should t rmly into the barrel with a signicant amount of resistance. NOTE: The barrel plug should
not be easy to remove and always inspect the O-rings to make sure they are not worn or cut.
Remove the Barrel Blocking Device only when you are getting ready to begin play or have been instructed to do so by
a eld safety ofcial.
Always keep your Barrel Blocking Device on your marker after you have nished playing. Keep it in place
even after you have emptied all paintballs and removed your air tank from your paintball marker.
WARNING: Inspect your Barrel Block Device regularly for wear and any tear if it is worn, replace it immediately.
Always have your Barrel Blocking Device in place on your markers barrel to insure safety and prevent accidents that
may cause permanent injury or even death.
English
To INCREASE your velocity FPS (Feet Per Second)
using the Allen wrench turn the Velocity Adjuster / Spring
Guide (#VTA007 or #VTA016) clockwise.
To DECREASE your velocity FPS (Feet Per Second)
using the Allen wrench turn the Velocity Adjuster / Spring
Guide (#VTA007 or #VTA016) counter-clockwise.
Decrease Velocity
Increase Velocity
VELOCITY ADJUSTMENT INCREASE / DECREASE
VTA007
VTA016
STP007
STP025