User Guide

How to Set the TIME and DATE on a PC:
NOTE: There are 2 ways to update the Time and Date Program
FACTORY File:
● Connect the USB cable to the device and the other end to the USB port of the computer
● Open the Device
● Inside you should find a text file named FACTORY
● Here you can edit the time and date, as well as other options
○ VOR:0 (0= Continues/ 1= Voice-activated)
○ BIT RATE:3 (0-7= 7 is a higher audio Bitrate)
○ GAIN:7 Does not function for this specific device
○ SEG:(300) Does not function for this specific device
○ DATE:2021-05-15 Edit the Date
○ TIME:15:40:00 Edit the Time
● Once the Time and date have been changed choose “Save”
● Unplug the unit from your computer and immediately make a brief recording just to make
sure the TIME and DATE was saved accurately
● Plug the device back into the PC and review the recordings
SetTimeTool:
● Connect the USB cable to the device and the other end to the USB port of the computer
● Open the Device
● Inside you should find a zipped folder called SetTimeTool
● Right-click the folder and a pop-up window should appear
● Click “Extract All” from the list of options
● The default location should be your device. Press the extract button in the bottom
right-hand corner.
● A new window will appear. Click the Settime folder.
● Click the SetDigitRecorderTm application
● A new window will appear. Confirm the date and time is correct then press the SetTime
button
● A final window should appear confirming the date and time was set.
● Unplug the unit from your computer and immediately make a brief recording just to make
sure the TIME and DATE was saved accurately
● Plug the device back into the PC and review the recordings
NOTE: The first steps of extracting the zipped folder will only need to be done on the first
use.