User Guide

How to Record a Voice-Activated AUDIO file:
● On the top of the device is an ON/OFF switch
● Slide the switch into the ON position.
● A RED LED light will turn on
● When the Red LED light is present. Press and Hold on the ( - ) button. The same red
light will then switch to a BLUE LED, then flash a few times before disappearing. When
you see the blue light you know you successfully started a voice-activated recording.
● When finished slide the switch into the OFF position.
● Please wait about 10 seconds before starting the next recording.
NOTE: Voice activation will not extend the battery life of the device.
NOTE: If the device runs out of power during the recording, it will finalize and save the
file before the battery dies.
How to Playback Files on the Device:
● Make sure the device is turned OFF first
● When in the off position, plug in your headphones.
● Slide the switch into the ON position.
● The device will begin playing an audio file
● Next to the solid light are 3 buttons ( - ) , (Play/Pause ) and ( + ) button
● The (Play/Pause ) button switches the device from the Music folder to the Recorded
files folder.
● The music folder contains a SpyCentre audio file, to switch over to your recorded files
tap the (Play/Pause ) button
● To skip to the next files press the ( - ) or (+) button.
To change the VOLUME of the recording being played Press and HOLD the ( + ) or ( - )
button.
NOTE: If the device is turned off while playing back audio on the device, the next time the
playback mode is entered the playback will continue where the file left off.