User Guide
page 2 page 3
EQBPL092
USER GUIDE
CAUTION
• The lights are designed in a way that protects them from average rainfall, but the device is not waterproof.
When installing the lights outdoors, place it under eaves so that rain doesn’t hit it directly. In the event of
heavy rain, water may enter and cause the lights to fail.
• When attaching the lights to the tripod, make sure you’ve screwed the device on tightly and the tripod
legs are firmly positioned.
• If installing the lights from above, make sure they aren’t positioned where they might cause damage if
they accidentally fall.
• Do not install the lights near curtains, clotheslines, trees, air-conditioners or on streets with passing
vehicles. That’s because the auto sensor might be triggered frequently, exhausting the batteries.
• Do not use in the bathroom. Excessive moisture may cause the lights to fail.
• Do not look directly at the LED since doing so could hurt your eyes.
• Do not bend the leg of tripod at the same position repeatedly since the stress could cause it to break.
• Do not disassemble the device since reassembling it could cause it to fail.
USE common SEnSE whEn DEcIDInG whERE to InStall thE lIGhtS.
Avoid locations likely to be hit by heavy rain. Install under an overhang instead.
Avoid installing the device where it sways with the wind. Fix it firmly.
Avoid placing it where it might fall on people or vehicles. Install it in a safe place.
Avoid installing the device near curtains, an air conditioner, trees or the road.
PARTS DIAGRAM
tIPS
Pushing the lights open too much or turning them by force could damage the device.
BoDy: With the pedestal fixed, the main body can slide along the curved slot by 90°. You can optionally
attach the magnetic disc at the bottom of the pedestal.
tRIPoD: Screw it into the threaded hole at the bottom of the pedestal.
accESSoRIES: Attach the metal plate to wooden wall with the mounting screw. Attach it so that the magnet is
at the bottom of the pedestal. Concrete plugs are used for attaching to concrete walls.
Before tightening a mounting screw, drill a prepared hole of 3 mm for wooden wall. and 6 mm for inserting a
concrete plug.
BoDy
accESSoRIES
tRIPoD
Mode changing switch
High-luminance white LEDs
Motion-detection sensor
Battery cover
Metal plate
Screw
Plastic plug
Light latch
Magnet
Base
EQBPL092
USER GUIDE