Use and Care Manual

7
INSTALLATION INSTRUCTIONS
B. Drive
3/4" (19mm) or
1/2" (12.7mm) locking screws
through frame holes into window sash (Fig.8).
Fig.8
C. To secure lower sash in place, attach right angle
sash lock with 3/4" (19mm) or 1/2" (12.7mm) screw
as shown in Fig. 9.
Fig.9
D. Cut foam window seal and insert it into the space
between the upper and lower sashes. Fig. 10.
Fig.10
FOAM SEAL
Measure the inner width
of the side curtain
1
2
3 4
5 6 7 8 9 10 11 12 13
14
15 16 17
1
2 3
4 5
6
Fig.11
6
INSTALL R1 HARDWARE
In order to minimize air leaks and ensure optimal
insulation, it is necessary to install the included R1
hardware to the side curtain.
Step 1. After the unit is installed to the window,
measure the inner width of the side curtain as shown
in Fig.11.
Step 2. Mark the width measured in Step 1, less 1/8"
onto the R1 insulation panel. Draw a line at this
measurement and cut the panel along this line. Fig. 12.
or
Fig.12
Step 4. Repeat on the other side.
Fig.13
Step 3. Slide the R1 insulation panel into the side
curtain. The patterned side faces indoors. Fig.13.