Installation Guide

IMPORTANT SAFEGUARDS
A. Read all instructions.
B. Do not touch hot surfaces. Use handles or knobs.
C. To protect against electrical shock, do not immerse cord or appliance in water or
other liquid.
D. Close supervision is necessary when any appliance is used by or near children.
E. Unplug from outlet when not in use and before cleaning. Allow to cool before
putting on or taking off parts.
F. Do not operate any appliance with a damaged cord or plug or after the appliance
malfunctions or has been damaged in any manner. Return appliance to the nearest
authorized service facility for examination, repair or adjustment.
G. The use of accessory attachments not recommended by the appliance manufacturer
may cause injuries.
H. Do not use outdoors.
I. Do not let cord hang over edge of table or counter, or touch hot surfaces.
J. Do not place on or near a hot gas or electric burner, or in a heated oven.
K. Extreme caution must be used when moving an appliance containing hot oil or
other hot liquids.
L. Always attach plug to appliance first, then plug cord into the wall outlet. To
disconnect, turn any control to “off”, then removed plug from wall outlet.
M. Do not use appliance for other than intended use.
N. Save these instructions.
NOTE: Do not use extension cord. If one must be used, use a cord with a
minimum of 14 gauge and no longer than 10 feet.
SPECIFICATIONS
Model
SR-182C/SR-183C/
SR-184C/SR-185C/
SR-186C/SR-187C
SR-341C/SR-342C/SR-343C/
SR-344C/SR-345C/SR-346C/
SR-347C
SR-652C/
SR-653C
Voltage 120V~ / 60Hz 208-240V / 50Hz
208-240V/
50-60Hz
Consumption 1800W 3400W 2700W
Dimension 12.6W x 15.16D x 4.53H in.
Weight 13.45 LBS
Power Range 350~1800W 1300~3400W 250-2700W
Cord Length 5.9 feet
Protection
Designs
Overheat protection. Automatic hazard detection. Circuit protection
sensor. High voltage. 20A fuse. Small object heat prevention. Thermostat.
Pan material detection
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a consumer ISM
equipment, pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio TV technician for help.
This device complies with part 18 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
1
10