INSTRUCTION MANUAL 3.6L HOT WATER POT: DUAL-PUMP SYSTEM MODEL: SP-3619 Thank you for purchasing your new SPT Hot Water Pot. Please read this instruction manual thoroughly and keep for future reference.
IMPORTANT SAFETY INSTRUCTIONS CAUTION The important information, herein, is intended to prevent possible injuries and damage to the machine. Please follow accordingly • Keep the unit out of reach from infants and children. Close supervision is necessary when used by or near children. WARNING • Do not place unit near walls or furniture, as steam and heat can damage walls and furniture by causing a change in color and shape. • Do not attempt to disassemble or repair the unit.
CAUTION – Continued CONTROL PANEL • Allow the unit to cool before maintenance and cleaning. • Do not close the lid with excessive force, as this may cause hot water to overflow. • Keep the plug (magnetic strips) and receptacle free of dust and foreign objects. • Do not place or use the unit on a wet or damp surface. Avoid using where it may come in contact with water • Do not operate the unit without water in the tank. This may cause damage to the unit.
PARTS IDENTIFICATION OPERATING INSTRUCTIONS 1. Open lid and fill with water During initial use or after a long period of storage, boil a full pot of water and discard. Please note that at initial use, there may be the smell of plastic, this is normal and odor will disappear. • Do not fill water directly under faucet to prevent wetting the control panel or power receptacle and cause malfunction. • Do not fill above the FULL line. • Do not pour water onto the main body or control panel. 2.
3. Connect power 4. Dispensing water • • There are two ways to dispense water: 1) Air (manual) Pump: Press down gently on air pump. 2) Auto Pump: first press unlock button to unlock then press dispense button. • Unit will automatically lock after a few seconds; or you can press the unlock button. The unit begins to function (boil) once power is connected. First connect the body plug to receptacle, then plug to wall outlet. The Power and Boil lights will come on.
MAINTENANCE AND CLEANING Please disconnect power and let the unit cool completely before cleaning. When not in use: 1) Disconnect power from wall outlet. 2) Remove cord from receptacle. 3) Detach upper lid. 4) Hold pot with both hands. 5) Pour out water from the indentation indicated by an arrow. NOTE • Do not wash under running water. • Do not place in a dishwasher. • Do not to wet the control panel and receptacle. • Pour water carefully, especially if water is still hot.
TROUBLE SHOOTING SYMPTOM POSSIBLE CAUSE Water does not boil when plugged in. (Power LED on) Dirty inner pot. Added water is already hot. Water level is below refill line. Unit may not function properly if used in high elevation or in very cold or hot conditions. In such conditions, unit may keep boiling or not reach boiling point. Unit will not switch to Keep Warm Unit will not switch to Boil Water level is too low.
