Use and Care Manual

PARTS IDENTIFICATION
INSTALLATION
WARNING: Do not plug in appliance until unit is fully assembled.
1. Install the Extension Tube onto the head assembly and secure by tightening the Lock Nut.
(Head assembly is pre-assembled, consists of front & rear grilles, fan blade and motor head)
2. Attach each leg to the Shaft Base’s Attachment Points, tighten screw to secure.
OPERATION
0 = OFF
1 = LOW
2 = MEDIUM
3 = HIGH
 Control knob can turn in either direction.
 Press down on the Oscillation Knob to oscillate fan.
 Pull up on the Oscillation Knob for fixed fan direction.
 To adjust height, loosen the Height Lock Nut and adjust
to desired height; tighten Height Lock Nut.
 Height is adjustable from 2.5 to 3 ft.
FRONT
GRILLE
NUT
FAN BLADE
GRILLE
LOCK
SHAFT BASE
LEG ATTACHMENT POINTS
FOUR-LEGGED
BASE
GRILLE SET
(FROTN & REAR)
REAR GRILLE
OSCILLATION KNOB
MOTOR HEAD HOUSING
MOTOR HEAD
HEAD
HEAD REST
LOCK NUT
EXTENSION TUBE
HEIGHT LOCK NUT
POWER CORD
RUBBER FEET
COVERS