Instructions / Assembly

2
1. Unscrew the spinner clockwise (this part may be packed separately in bag)
and unscrew plastic nut counterclockwise to remove. Fix the rear grill onto the
motor shaft, replace plastic nut and turn clockwise to tighten. (Fig.1)
2. Insert the blade onto shaft - make sure the rotor shaft pin is tted into the groove
on the blade. Turn the spinner counterclockwise to tighten the blade. (Fig.2)
3. Fix the front grill to the rear grill with then use the fasten clip with locking screw to
secure the front grill. (Fig.3)
GRILL & FAN BLADE ASSEMBLY
Fig.1 Fig.2 Fig.3
MOUNTING ON THE WALL
Fan should be installed on solid wood or a pillar which stands
vertically to oor.
CAUTION: To prevent the fan from falling off, DO NOT install
it on walls less then 4 inches thick or made of materials that
are easily damaged.
1. Installing the mounting bracket.
Fix the supplied mounting bracket to the wall using
the two screws. Be sure bracket is rmly in place.
NOTE: The bracket should be placed at least 12
inches below the ceiling and at least 12 inches
from adjoining wall.
2. Installing the fan.
Mount the fan onto the bracket by inserting the bracket
catch into the open slot on.
REMOTE CONTROLL (Fig.4)
OPERATING INSTRUCTION
“ ” ON/OFF KEY
Press to turn on and press again to turn fan off.
“ ” TIMER KEY
Press to set timer: 30 minutes, 1H, 2H and 4H. The corresponding
time indicator will illuminate.
When none of the timer indicators are lit, the unit runs continuously.
Fig 4