Installation Guide
7
7.  Trouble shooting 
The following issues can be handled by the user. If problem persists, please contact Sunpentown 
Customer Service at 1-800-330-0388. 
No power 
Unit is not plugged in. Check outlet and circuit. 
Low voltage. 
Power failure power. 
Odor 
Odorous foods should be closely wrapped. 
Check for any rotten food. 
Clean the interior. 
Long-term operation of 
compressor 
It  is normal  for  the unit  to operate  for  longer periods  of time 
during the hotter days when ambient temperature is higher. 
Do not put too much food in the unit at one time. 
Wait for food to cool down before placing them in the unit. 
Frequent opening of refrigerator door. 
Light does not illuminate 
Check if refrigerator is connected to power. 
Check if bulb is damaged.   
The refrigerator door cannot 
close properly 
Too much food inside the unit and the door is blocked by food 
packages. 
Adjust the leveling leg. 
Loud noises 
Check if unit is leveled. 
Noise cause by the refrigerant circulating is normal   
7.1 NOTES: 
• 
The refrigerator may emit heat during operation, especially in summer, this is caused by 
the radiation of the condenser, and it is a normal phenomenon. 
•  Condensation: condensation may be detected on the exterior surface and door seals of 
the freezer when the ambient humidity is high. This is a normal. Simply wipe away the 
condensation with a dry towel. 
• 
Buzz: A buzz will be generated by running compressor during starting up or shutting 
down. 
•   
8. 
TIPS FOR ENERGY SAVING 
•  Try not to open the door too often, especially when the weather is humid and hot. Once 
you open the door, close it as soon as possible. 
•  Check the unit’s ventilation periodically to ensure adequate air circulation behind the 
unit. 
• 
In normal temperature conditions, please set the thermostat at the middle setting. 
•  Before loading the appliance with packages of fresh food, make sure they are cooled to 
ambient temperature. 
•  Ice and frost layer increase energy consumption, so clean the appliance as soon as the 
layer is 3-5 mm thick. 
• 
Keep the rear (condenser) free of dust and impurities. 
•  The appliance should be located in the coolest area of the room, away from heat 
producing appliance or heating ducts and out of direct sunlight. 










