ICE MAKER Model: IM-101 / IM-101S INSTRUCTION MANUAL It is important that you read these instructions before using your portable ice maker and we strongly recommend that you keep them in a safe place for future reference.
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS …………………………………….2 PREPARING YOUR ICE MAKER FOR USE ……………………………….3 GETTING TO KNOW YOUR UNIT • PARTS IDENTIFICATION …………………………………………………4 • CONTROL PANEL & LCD DISPLAY …………………………………….5 • LCD DISPLAY SYMBOLS ………………………………………………...5 OPERATING PROCEDURES & MAINTENANCE • UNPACKING YOUR ICE MAKER ……………………………………….
IMPORTANT SAFETY INSTRUCTIONS Your safety and the safety of others are very important. We have provided many important safety messages in this manual in regards to your appliance. Always read and obey all safety messages. This is the safety alert symbol: All safety messages will follow the safety alert symbol and the word “DANGER” or “WARNING”. DANGER WARNING These words mean: You can be seriously injured if the instructions are not followed.
PREPARING YOUR ICE MAKER FOR USE IMPORTANT SAFETY TIPS When using electrical appliances, basic safety precautions should be followed to reduce the risk of fire, electric shock and injury to persons or property. Read all instructions before using any appliance. • Do not operate this or any other appliance with a damaged cord • Connect to properly polarized outlets only. No other appliance should be plugged into the same outlet.
GETTING TO KNOW YOUR UNIT PARTS IDENTIFICATION 1. COVER: with a transparent window to allow interior visibility 2. CONTROL PANEL: easy to use controls. LCD display with blue backlight 3. WATER DRAIN CAP: for draining water from water reservoir 4. ICE BASKET 5. ICE SCOOP 6. ICE SHOVEL 7.
CONTROL PANEL & LCD DISPLAY 1. POWER: to turn the unit ON or OFF 2. SELECT: press to select the size of the ice cube (Small, Medium or Large) 3. TIMER: to set or cancel ON or OFF timer (refer to page 9) 4. CLEAN: starts the self-cleaning function (refer to page 7) 5. LCD display window: displays your settings and symbols LCD DISPLAY SYMBOLS 1. POWER signal 2. ICE FULL: indicates the ice basket is full 3.
OPERATING PROCEDURES UNPACKING YOUR ICE MAKER 1. Remove all exterior and interior packaging materials. Check that the ice basket and ice scoop is included. If any parts are missing, please contact our customer service. 2. Clean the interior with lukewarm water and a soft cloth or clean the unit using the Self-Clean function (see page 7). Take out the ice basket before cleaning. 3. Find a location for your ice maker where it’s protected from direct sunlight and other sources of heat (i.e.
CLEANING & MAINTENANCE Please thoroughly clean your ice maker before initial use. EXTERIOR: the outside of the ice maker should be cleaned regularly with a mild detergent solution and warm water. Always use a soft cloth to avoid scratching or damaging the housing. INTERIOR: please use the following Self-Clean function: 1. Take out the ice basket 2. Add water and vinegar or lemon juice mix (1:1 ratio) 3. Plug in unit, press and hold the CLEAN button for approximately 6-7 seconds, then release.
USING YOUR ICE MAKER OPERATING DETAILS 1. Open the cover, remove the ice basket and pour water into water reservoir. Keep water level below the level mark. 2. Plug the unit into an applicable power supply outlet. 3. Press POWER button on the control panel to start the ice making cycle. 4. Select desired ice cube size by pressing the SELECT button. If room temperature is below 60°F, select the small ice size to avoid ice sticki ng together. 5.
TIMER SETTING PROCEDURE How to set ON-TIMER program When the unit is off, you can set the unit to start in x-number of hours: 1. Press the TIMER button on the control panel. Timer indicator, will flash in the Timer Set window. 2. Press the SELECT button to change the timer delay to your desired number of hours, from 1.0 to 18 hours, and back to 0.5, 1.0 hours. Each press is an increment of 0.5 hours. 3. A few seconds after releasing the buttons, the time digit will display the set time invariably.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE “ ” symbol is flashing “ ” symbol is displayed “ ” symbol is displayed “ ” symbol flashes for 20 seconds Ice cubes stick together. Ice making cycle is normal but no ice is made. SOLUTION Lack of Water Stop the ice maker and fill water Ice basket is full Remove ice from ice basket Ice shovel cannot rotate. Check if ice-cubes are blocking the ice-shovel.
SUNPENTOWN Your Guarantee If this product is found to be faulty as a result of faulty materials or workmanship within one year from date of purchase, it will be repaired free of charge. This guarantee is subject to the following terms: • Sunpentown must be notified of the fault. • Proof of purchase must be presented to Sunpentown’s nominated representative. • The warranty will be void if the product if modified, misused or repaired by an unauthorized person.
