Datasheet

6
Document number: DT13-08-201902-E
Rev. & Date: V2019-1 2019.10.24
2.7V 350F CDCM-SPD
6
Please notice below points when you start use SPSCAP.
1) The SPSCAP gets polarity through aging/testing process before it is packed, so please mount it in
accordance with its polarity to maintain the best condition;
2) Please only apply SPSCAP at rated voltage. If you apply more than rated voltage, capacitor will be
damaged or broken due to electrolyte inside will be electrolyzed;
3) Ambient temperature greatly affects the lifetime of the capacitor, by reducing the temperature by
10℃, lifetime can be approximately doubled;
4) Storage: In long term storage, please store SPSCAP in following condition:
⚫ Temp.: 15 ~ 35℃
⚫ Humidity: 40 ~ 75 %RH
⚫ No-dust, non-acidic and/or non-alkaline atmosphere
⚫ Avoid direct sun light
5) Do not disassemble SPSCAP. It contains electrolyte;
6) Avoid serious mechanical impacts onto capacitor, such as force or twist capacitor;
7) Please contact us if you want to subject SPSCAP to severe vibrating conditions exceeding rated
specification;
8) Please contact us if you want to connect a certain number of single capacitor to make a module;
9) Over-rated voltage may be applied to a single SPSCAP in series connection due to the deviation of
capacitance and ESR of each SPSCAP. Please inform us if you are using SPSCAP in series
connection and please design so as not to apply over-rated voltage to each capacitor, and use
SPSCAP from same date code/lot.