Instructions / Assembly

INSTALLATION
1. Unscrew exisng showerhead from shower arm (Fig. A).
2. If your showerhead has an integral ball joint it should
either be replaced with a standard 1/2 inch threaded
shower arm or an adapter (see Fig. B). Ball adapters
can be purchased from most hardware stores.
3. Screw filter housing (Back) onto shower arm (Fig. C).
4. Screw shower head onto filter housing (Front).
5. Do not use a showerhead with a shut-off valve.
OPERATION
BEFORE ENTERING THE SHOWER
1. Acvate filter by running hot water through the shower
system.
2. COOL TO DESIRED TEMPERATURE BEFORE ENTERING
SHOWER.
3. Replace filter every 25,000 gallons or 12 months,
whichever comes first.
BACKFLUSHING
1. Remove the Shower Filter from the shower arm.
2. Remove the showerhead from the filter.
3. Turn the shower filter around and a<aché the back-
flushing coupling (supplied) to the outlet of the Shower
Filter.
4. A<ach the coupling to the shower arm (Fig. D).
5. Turn on the water and flush the Shower Filter with
warm water for several minutes at full flow.
6. Remove the unit and reassemble using Teflon joint
sealing tape if needed.
(OVER)
Filter Housing
(Back)
USE & CARE INSTRUCTIONS
PERMA SEAL®
Model SR
Filter Housing
(Front)
PERFORMANCE DATA: (Model SR)
Rated Service Flow – 2.5 gallons per minute / 9.5 liters per
minute
Rated Service Life for Free Chlorine removal – 25,000 gallons /
94,635 liters or 1 year (whichever comes first)
Maximum Working Pressure – 125 pounds per square inch /
860 kilo pascals.
Maximum Operang Temperature - 120° Fahrenheit / 49° Cel-
sius.
• While tesng was performed under laboratory condions.
Actual performance may vary.
• This system is not intended to be used as a drinking water
treatment unit.
• Both the system and installaon must comply with appli-
cable state and local regulaons.
This Shower Filtraon System has been tested for reducon of
free chlorine. The concentraon of free available chlorine in
water entering the system was reduced to a concentraon less
than or equal to the permissible limit for water leaving the
system. This system has not been evaluated for free chlorine
reducon in the presence of chloramines. Free chlorine reduc-
on performance may be impacted by the presence of chlora-
mines in the water supply.
NOTICE OF LIMITATIONS
1. Designed for potable water systems only.
2. The shower filter is not to be used for drinking
purposes.
LIMITED ONE-YEAR WARRANTY:
At the me of purchase, it is the owner’s responsibility to com-
plete the warranty informaon, keep proof of purchase of the
unit and demonstrate that proper filter maintenance was per-
formed. The provisions of this warranty shall not apply to any
product that has been subject to misuse, neglect, over-
ghtening, lack of, or improper filter replacement, repaired or
altered by anyone other than a Sprite service representave
and will VOID the warranty in it’s enrety. Transportaon
charges on units submi<ed for repair or replacement under
warranty Register warranty on-line at
www.spriteshowers.com
RECYCLE SHOWER FILTER
1. Carefully poke a hole in the screen of the
filter and empty contents into garden soil.
2. Place the filter cartridge in with recyclables.
Sprite Industries, Inc.
1791 Railroad St., Corona, CA 92880