Use and Care Guide

I
NSTALLATION
1.
Remove existing shower head
from shower arm.
2. Screw hose-bracket onto shower arm.
3. Remove the paper seal from end
of fi lter handle.
4. Insert (2) rubber washers into couplers at
each end of hose.
5. Attache on end of Hose to Bracket
and the other to Filter Handle.
6. Place Filter Handle into Bracket.
7. RUN HOT WATER THRU THE FILTER
FOR A FULL FIVE MINUTES
AFTER INSTALLING.
OPERATION
BEFORE ENTERING THE SHOWER.
1. Activate fi lter by turning the shower-water to “full-hot”.
2. Cool to the desired temperature before entering shower.
To ensure over
75% free-chlorine removal
, replace the model
HHC Filter Cartridge every 3 months or 3,000 gallons,
whichever comes fi rst.
MAINTENANCE
Back-fl ush monthly or as needed by reversing the direction of the
cartridge in the handle.
FILTER CARTRIDGE REPLACEMENT
The fi lter cartridge should be replaced every 6 months or sooner
(depending on individual water conditions).
1. Remove cartridge by unscrewing handle.
2.
Remove paper seals from each end
and lubricate o-rings with a
small amount of Vaseline.
3. Insert cartridge into handle and screw onto showerhead.
4. Flush for fi ve minutes before using.
“REMINDER” DECAL
Is designed to remind you to change the fi lter
cartridge every 3 months.
1. Use a pen to fi ll out the installation and
replacement date.
2. Peel sticker off of backing and apply to a
corner of a dry mirror (or any glass surface)
Hand Held Filtered Shower
Shower Handle with Built-in Filter
Nozzle
Replaceable Filter
Cartridge (modlel HHC)
Filter Handle
Washer
Washer
Hose
Hose-bracket
WARRANTY REGISTRATION
Register Sprite Shower Filters on-line at
www.spritewater.com
or fi ll
out and return the warranty registration card.
Performance Data:
Sprite Shower Filter Model HH
Rated Service Flow – 9.5 liters per minute / 2.5 gallons per minute
Rated Service Life at 75% free chlorine removal – 111,385 liters /
3,000 Gallons
Maximum working pressure – 860 kilo pascals / 125 pounds per
square inch
Maximum operating temperature - 49° Celsius / 120° Fahrenheit
Installation – Attaches to shower-arm. No Tools required.
Notes:
• While testing was performed under standard laboratory conditions,
actual performance may vary.
• This system is not intended to be used as a drinking water treatment unit.
• Both the system and installation must comply with applicable state and
local regulations.
This Sprite Shower Filtration system has been tested
and Certifi ed by NSF International against NSF/ANSI
Standard 177 for the reduction of free available
chlorine. The concentration of free available chlorine
in water entering the system was reduced to a concentration less
than or equal to the permissible limit for water leaving the system,
as specifi ed in NSF/ANSI 177. This system has not been evaluated
for free available chlorine reduction performance in the presence of
chloramines. Free available chlorine reduction performance may be
impacted by the presence of chloramines in the water supply. Please
contact your local water utility to determine if chloramines are used
in treating your water.
Notes on NFS Test Protocol:
Minimum chlorine reduction per NSF/ANSI 177 shall be listed as
>
50% free available chlorine (FAC) when used with an infl uent
challenge water of 2 mg /L FAC.
Average concentrations shall be the arithmetic mean of all reported
infl uent challenge or product water concentrations (the detection limit
value shall be used for any nondetectable concentration). The specifi ed
average percent reduction shall not be greater than the reduction
calculated using the arithmetic means of the
infl uent challenge and the product water
concentrations respectively.