User manual

16
Telephone Operation
When the person at the base answers, press
TALK
. The call is released from hold and
transferred to the base.
To transfer a call from the base to the hand-
set, press
INTCM/PAGE
. The call is put on
hold, and
Paging
and
Hold
appear. When
the person with the handset answers, press
SPEAKER
. The call is released from hold and
transferred to the handset.
MEMORY DIALING
You can store up to 30 phone numbers in
memory (20 in the handset’s and 10 in the
base’s memory), then dial a stored number
by entering its memory location number.
You can also store a name with each number
in the handset’s memory.
Use the supplied memory sticker to record
the numbers you stored in the base’s memo-
ry. Peel the backing from the sticker and at-
tach the sticker to the base.
Storing a Number in the Handset's
Memory
Notes:
• The phone beeps five times exits the
storing process if you wait more than 20
seconds between each keypress.
• If you receive a call during memory
entry, the phone exits the storing pro-
cess.
1. Lift the handset.
2. Hold down
MEM
until
Memory Store
and a list of memory location numbers
appear.
3. Press a number
(01-20
) or
VOL/CID
8
88
8
or
9#
9#9#
9#
to choose a two-digit memory loca-
tion. Precede a single digit location num-
ber with 0 — 01, 02, 03, and so on.
4. To store a name, press
SELECT/CHAN-
NEL
.
Store Name
appears.
If you do not want to enter a name, skip
to Step 6.
5. To enter a name, press
VOL/CID
8
88
8
or
9
99
9
to select the characters and
6
66
6
or
7
77
7
to move the cursor.
Repeatedly press
VOL/CID
9
99
9
to view
the characters in alphabetical order.
(The display shows uppercase letters
first, then lowercase letters, numbers,
and special characters.)
Notes:
• Press
VOL/CID
8
88
8
to see the charac-
ters in reverse alphabetical order.
• You can hold down
VOL/CID
8
88
8
or
9
99
9
to scroll rapidly through the charac-
ters.
• If you make a mistake, move the cur-
sor over the error, then enter the cor-
rect character, or press
INTCM/DEL
to
delete a character. To delete all the
characters, hold down
INTCM/DEL
for
at least 1 second.
6. Press
SELECT/CHANNEL
.
Store Num-
ber
appears.
7. Enter the phone number and any tone or
pause entries (see “Using Tone Services
on a Pulse Line” on Page 15 and “Enter-
ing a Pause” on Page 17).
8. Press
SELECT/CHANNEL
. The phone
beeps and
Memory nn Stored
appear (nn is the location number you
selected). After 2 seconds,
Memory
Store
appears. Repeat Steps 3–8 to
store more numbers.
9. When you finish, press
MEM
.
43-5522.fm Page 16 Tuesday, September 12, 2000 3:12 PM