Specifications

Page 10
IPv6 Support
Yes
Peak UE DL
Throughput
DL=B41/580 Mbit/s , 4CA 256QAM
B25/600 Mbit/s (3CA 256QAM)
DL Transmission
Mode
DL Transmission Mode 1 -9
Frame Type
Frame Type 1 FDD
Frame Type 2 TDD, 5ms periodicity
Tx/Rx
B41: 4T8R
B25: 2T8R
Scanning
DeNB Selection and Ranking
PDCL --> Donor Selection Algorithm
4. Installation
The Sprint TREBL unit is placed on the windowsill to receive the signal from outdoors and boost it
indoors. The following steps instruct on the proper positioning and setup of the Sprint Magic Box
unit for optimal service.
4.1 Unpacking and Checking the unit
 Carefully unpack the Sprint TREBL unit from the box.
 Inspect the unit for any damage and check that all the accessories are in the box.
 Remove the Power Supply (included) from the packaging.
4.2 Finding the Best Location
Choose an appropriate window at the suitable side of a building is vital to get the best performance
 The Sprint TREBL has a built-in capability to survey the 4G signal from suitable provider cell
towers & also use GPS to accurately determine its location. It can do this for multiple windows
in the same or on multiple floors, ideally in all four directions of the building.
 Connect the power supply to the underside of the AU 587 and place it at the 1st window
(ideally in the middle of the window).
 Wait for the RF survey to complete
 Go to the next window and repeat the survey process
 Test as many windows as possible in all four directions as possible
 Once you finish testing all locations, select the best location out of all surveyed locations and
press “Install Here” in the location
4.3 Initial Setup