Quick Start Guide

14 15
Adjusting Your Shade’s Limits and Home Position
Adjusting Your Shade’s Limits and Home Position
For the Multi-Channel Remote
1. On the remote, press and hold
the MENU/RIGHT button for
2 seconds to enter the menu.
2. Select SHADE > LIMITS.
3. To proceed past the warning
message, press and hold
the MENU/RIGHT button for
2 seconds.
4. Scroll left and right to select
the shade you want to adjust
the upper limit for.
5. With UPPER selected, press and
hold the MENU/RIGHT button
for 2 seconds.
If the shade isn’t already at the current
upper limit, it will move to that position.
If the shade is already at the current
upper limit, it will jog.
6. Use the UP or DOWN
buttons to move your shade to
the new upper limit.
7. Press and release the MENU/
RIGHT button to set the
upper limit.
The shade will jog. This means you’ve
set your new upper limit.
Adjusting the Lower Limit
Don’t attempt to move the lower limit to a position lower
than the preset limit—that could damage your shade.
If your remote currently controls a group of shades, you’ll first need
to target the specific shade that you want to adjust the lower limit
for. To do that, perform the following steps:
1. On the remote, press and release the program button
on the back.
The remote LED will ash green.
2. On the shade you want to adjust, press and hold the program
button for 3 seconds.
The shade LED will ash green and the shade will jog.
Even after you target a shade, all of the shades in the group
will still move with the remote. However, nontargeted shades won’t
accept the new lower limit until you target them specifically.
For the Two-Button or Single-Channel Remote
Before You Start
TARGET
SHADE