Quick Start Guide

28 29
Pairing Your Remotes and Shades Pairing Your Remotes and Shades
Remove a Shade from the Multi-Channel Remote
You might need to do this if your shade needs to be sent in
for repairs.
1. On the remote, press and hold the MENU/RIGHT button
for 2 seconds to enter the menu.
2. Select ZWAVE > EXCLUDE.
3. On the shade, press and hold the program button for
3 seconds. When the shade LED flashes green, release
the button.
The remote’s screen will indicate that the shade has been removed from
the remote. The shade will jog.
Clear All Channels
If you want to clear all your current channel assignments and
start over with assigning shades to channels, follow these steps.
1. On the remote, press and hold the MENU/RIGHT button for
2 seconds to enter the menu.
2. Select SHADE > CLR CHNLS > CONFIRM.
At this point, the shade menu is cleared. This means you can’t select a
shade from the remote or assign shades to a channel until you find
them again.
3. Select FIND ALL > BEGIN.
The screen will display SEARCHING (this might take a little while), and then
display how many shades have been found.
Your shades are now visible in the remote again. To create new channel
assignments, follow the steps on page 10.
Pair a Second Remote with a Shade That’s Already
Controlled by a Multi-Channel Remote
If you paired a group of shades with a multi-channel
remote in the previous section, you might still want to
control each individual shade within that group with
separate, individual remotes.
To do that, follow these steps.
1. On the multi-channel remote, press and hold
the MENU/RIGHT button for 2 seconds.
2. Select ZWAVE > INCLUDE.
3. On the individual remote, press and
hold the program button for
3 seconds. When the remote LED
flashes green, release the button.
4. On the individual remote, press
and release the program button on
the back.
The remote LED will flash green.
5. On the shade you want to pair
the individual remote with, press
and hold the program button for
3 seconds. When the shade LED
flashes green, release the button.
The LED on the individual remote will turn
green, and the shade will jog once. Both of
your remotes will now control the shade.
6. Repeat steps 1–5 for each shade
you want to control with an
individual remote.