Instruction Manual

2019 / www.airventuri.com / 216-292-2570

CO2 Installation

1. Press the magazine release.

The magazine will drop free

from the rie.

2. Turn the capsule piercing screw

counter-clockwise with the

included allen key.

3. Insert CO2 capsule as shown

4. Turn capsule piercing screw

clockwise with the provided allen key

until tight. The capsule is now pierced.

5. Insert magazine

NOTE: A slight seepage of CO2 may occur until piercing screw is tight.

NOTE: Never try to force any CO2 capsule into or out of place. Do not store your Airgun with a

CO2 capsule in it. If you know you will not be using your Airgun for an extended period of time,

empty the CO2 capsule and remove it from the Airgun. This is very important to remember, as it

will prolong the longevity of your Airgun seals.

USE ONLY 12 GRAM CO2 CAPSULES. ANY

ATTEMPT TO USE OTHER TYPES OF GAS CAPSULES

COULD BE EXTREMELY DANGEROUS AND COULD RESULT IN SERIOUS INJURY

OR DEATH. GASES OTHER THAN CO2 COULD RESULT IN AN EXPLOSION OR

RUPTURE OF THE AIRGUN.

WARNING:

KEEP HANDS AND FACE AWAY FROM ESCAPING

CO2 GAS. IT CAN CAUSE FROSTBITE IF ALLOWED

TO COME IN CONTACT WITH SKIN. ALWAYS MAKE SURE THE CO2 CAPSULE IS

EMPTY BEFORE ATTEMPTING TO REMOVE IT FROM THE AIRGUN BY SLOWLY

TURNING THE GAS CAPSULE PUNCTURE SCREW COUNTER-CLOCKWISE ALL

THE WAY UNTIL YOU NO LONGER HEAR THE ESCAPE OF THE CO2 GAS.

WARNING: