Manual

REMOVING THE BOLT
Grasp the bolt roller and, while sliding it forward, lift it upward and outward to the right front with a slight counter-
clockwise rotating motion [see figure 19].
ASSEMBLY OF BARREL & RECEIVER GROUP
REPLACING THE BOLT
Place the barrel and receiver on the table, sights up, muzzle pointing away from you. Hold the bolt by the roller and
locking lug and place the rear of the bolt on the bridge of the receiver, with the firing pin tang pointed down. Turn the
bolt slightly clockwise until the tang of the firing pin clears the bridge. Guide the left locking lug of the bolt into its groove
in the left slide of the receiver. Lower the right locking lug on its bearing surface and slide the bolt halfway to the rear.
31
Fig. 19
BOLT EXPLODED VIEW
The bolt should NOT be disassembled.
It does NOT require internal cleaning.
To disassemble the bolt requires a
special re-assembly tool.
Any problems with the bolt
should be dealt with
directly by a professional
Springfield technician.