Manual

22
1. Retract slide to the takedown notch.
2. Align disassembly notch on slide with slide stop.
3. Remove slide stop and slowly remove slide from receiver keeping in mind that the slide is under
spring pressure until it clears the receiver.
4. With the bottom of the slide facing up, press the guide rod head forward until enough of the rod is
exposed and firmly snap the takedown piece over the rod. (See fig. 58-1 and 2)
5. The slide assembly can now be disassembled as previously laid out. (Described in section 4, Step 2).
ALTERNATE METHOD FOR DISASSEMBLY
Figure 58-2
Figure 58-1
22
Assemble by reversing the order of disassembly.
Note: Be sure to flip barrel link forward before
installing barrel into slide.
SECTION 4: ASSEMBLY
MICRO-COMPACT, ULTRA COMPACT, V-10, COMPACT, &
CHAMPION MODELS
An improperly
assembled firearm
is dangerous and
should not be fired.
Always consult an experienced gunsmith if you
experience any difficulty or have any questions
concerning assembly procedure.
Model 1911-A1 Pistols are classified firearms and dangerous
weapons. Injury or death to you or others may result from
unsafe or improper use.