Manual

17
Step 2 - Slide Stop Removal
1. Align disassembly notch on slide with slide stop.
2. Press slide stop shaft on right side of frame.
3. Remove slide stop from left side.
4. Pull slide assembly forward off frame.
Step 3 - Recoil Spring Assembly Removal
1. Push recoil spring assembly forward to expose
a small, pin-sized hole. (Fig. 33-1)
2. Insert the provided pin (or cut a paper clip so
that it extends 1/16” on both sides of guide
rod) into pin hole.
3. Remove recoil spring housing from the rear
of the slide. (Fig. 33-2)
4. Remove the barrel from the front of the slide.
S
P
RIN
G
FIE
LD
A
RM
O
R
Y
T
R
P
MODEL 1911-A1
CAL.45
SECTION 2: DISASSEMBLY
TRP OPERATOR MODELS
Figure 33-1
Figure 33-2
17
Assemble by reversing the order of disassembly.
Note: Be sure to flip barrel link forward before
installing barrel into slide.
SECTION 2: ASSEMBLY
TRP OPERATOR MODELS
An improperly
assembled firearm
is dangerous and
should not be fired.
Always consult an experienced gunsmith if you
experience any difficulty or have any questions
concerning assembly procedure.
Model 1911-A1 Pistols are classified firearms and dangerous
weapons. Injury or death to you or others may result from
unsafe or improper use.