Product Manual
7. Turn on the heating element by turning the heater toggle switch
on.
Allow 11/2 hours for the water temperature to reach 150F.
8. Turn on the oil skimmer using the on/off switch.
9. When the water temperature has reached at least 140F, add
detergent following the detergent manufacturers directions.
You can determine the water temperature by dialing the
thermostat knob backward until you hear the heat contactor
“clunk” open to shut-off the heating elements.
You can pour the detergent directly in the tank, or you can
simply pour it on the floor beneath the turntable.
In the future, you may want to increase or decrease the
detergent concentration depending on the cleaning results.
10. Close the door and run a 15 minute wash cycle to mix the
detergent in solution.
11. During the wash cycle, walk around the machine checking for
any leaks. Make sure the turntable drive motor is working.
12. At this point, you have checked every aspect of your machine.
To thoroughly coat the inside of your machine with the rust
inhibiting agents in the detergent, run at least two (2) hours
worth of wash cycles at this time and for each of the next two
(2) days. The more wash time you run, the more the cabinet
gets coated with rust inhibitors.
IF YOU ENCOUNTERED ANY PROBLEMS DURING START-
UP, CALL YOUR KLEENTEC DEALER.
8